Attachment Tilt Switch - Xtreme Manufacturing XR1147 Operation And Safety Manual

Operator Cab
The boom control joystick has variable motions from the
center position that control boom and tilt functions. It is used
to raise, lower, extend, retract the boom, tilt the carriage (or
attachment), and control auxiliary functions (when equipped
with a carriage or attachment with additional functions).
• The boom control joystick is a variable speed control.
Function speed is proportional to handle movement. The
more the handle is moved in the appropriate direction,
the faster the corresponding function will occur.
• Increasing engine speed can increase boom lift and
extend speed.
Boom Control Joystick Functions
Function
Aux Button 1 Move forks outward (adjustable carriage)
Aux Button 2 Move forks inward (adjustable carriage)
Joystick Enable When depressed it enables joystick func-
Trigger tions. If not depressed, joystick is inert
Trigger must be enabled (pulled in) to
Sway Enable Trigger
Tilt Thumbstick
Sway
Enable
Button
Joystick
Enable
Trigger
Figure 50. Joystick Enable Trigger and Sway Enable Button
The Joystick Enable button needs to be depressed in order
for the joystick to be operational. This avoids unintended joy-
stick moves, such as hitting the joystick with your elbow, etc.
The Sway Enable button on the joystick is used to enable the
machine frame sway before lifting any loads.
AUX
CONTROL
BOOM
FORK TILT
RETRACT DOWN
SWAY
LEFT
FORK TILT
UP
Purpose
AUX
CONTROL
activate the frame sway function
Control carriage tilt (UP/DOWN)
BOOM
FORK TILT
RETRACT
DOWN
SWAY
LEFT
FORK TILT
UP
BOOM
EXTEND
SWAY
RIGHT
JOYSTICK
ENABLE
Figure 51. Boom Control Joystick Functions
NOTE: Two (2) boom functions can be performed at the
same time by moving the handle into the corner between (2)
functions.

Attachment Tilt Switch

The Attachment Tilt Switch located on the top of the joystick:
• Controls the attachment tilt functions by rolling the
switch upward and downward.
• Is a variable speed switch. Function speed is proportional
to how far the switch is rolled. The more the switch is rolled
in the appropriate direction, the faster the corresponding
function will occur.
• To tilt the attachment down: Roll switch (A) downward (1)
• To tilt the attachment up: Roll switch (A) upward (2)
NOTE: The attachment carriage will retain the set angle
throughout boom raising, lowering, retracting, or extending
operations.
43
A
AUX
CONTROL
BOOM
EXTEND
B
SWAY
RIGHT
AUX
CONTROL
C
D
E
18408-001
F
G
H
Operation Manual
JOYSTICK
ENABLE