Attachment Removal - Xtreme Manufacturing XRM945 Operation & Safety Manual

Operation

Attachment Removal

NOTE: To remove a standard carriage with forks, spread
the forks apart on the carriage shaft. This provides
adequate support for the carriage to stand alone.
1. Bring the forklift to a complete stop.
2. Move the travel select lever to NEUTRAL (N).
3. Set the Parking Brake switch to ON (engaged).
4. Extend the boom approximately 18 to 20 inches (0.46
to 0.5 meters).
5. Tilt the attachment backward.
6. Disconnect the quick attach couplers (this only
applies to attachments with a quick attach hydraulic
system).
Figure 7-33. Disconnect Quick Attach Couplers.
(A) Female Coupler. (B) Male Coupler.
Page 62
7. Raise the quick attach lock lever.
Figure 7-34. Raise Quick Attach Lock Lever.
8. Pull out the quick attach pin at the bottom of the
quick attach link.
Figure 7-35. Pull Quick Attach Pin From Attachment and Quick
Attach Link.
XRM945
Xtreme Manufacturing, LLC