Boom Angle Indicator; Boom Extend Letters; Frame Level Indicator; Telehandler Lifting Points - Xtreme Manufacturing XR1147 Operation And Safety Manual

Operator Cab

Boom Angle Indicator

The boom angle indicator is located on the left side of the
boom and is visible from the operator's seat. Use the boom
angle indicator to determine the boom angle when referring
to load capacity charts. Refer to the LOAD CAPACITY CHARTS
section of this manual for more information.
NOTE: The boom angle indicator is a plumb arrow with
angular graduations from -50 to +700
Figure 55. Boom Angle Indicator

Boom Extend Letters

As the boom is extended, the boom extend letters on the left
side of the boom are visible to the operator. These letters
indicate boom extension as it corresponds to the load capacity
charts.
Figure 56. Boom Extend Letters

Frame Level Indicator

The frame level indicator is mounted on the upper right
corner of the operator's cab. The frame level indicator allows
the operator to view if the Telehandler has been positioned in
a level condition.
Figure 57. Frame Level Indicator

Telehandler Lifting Points

The XR1147 lifting points are shown below. The Telehandler
should only be lifted if lifting points are installed.
Ensure that no one is in the work radius before
lifting Telehandler to avoid crushing hazard.
UNLADEN VEHICLE WEIGHT: 30,140 lbs
UNLADEN CENTER OF GRAVITY
FORWARD LIFT POINT
Figure 58. XR1147 Lifting Points
45
Warning
MODEL: XR1147
AFT LIFT POINT
75.75"
APPROX
125.0"
WHEELBASE
Operation Manual
18241-014