To Mount The File System Via Nfs - Agilent Technologies 1660C Series User Manual

To mount the file system via NFS

The logic analyzer must be on and completely booted up before you can mount
the file system. Once power is applied and the Analyzer Configuration menu is
displayed, allow an additional 15 seconds before attempting to mount the
system.
Be sure to unmount the logic analyzer's file system before turning off the logic
analyzer. If you don't do this, you may get a "stale NFS file handle" error
message the next time you try to mount. If you get this message, unmount the
file system and try mounting again.
From Computers Running the UNIX Operating System
The syntax of the mount command is typically
mount [symbolic name|IP address]:/[control|data] /[directory
name]
The symbolic name is the host name of the logic analyzer as set up by your
system administrator. Typically, this name is found in the /etc/hosts file
on your computer or returned by a name server. It is equivalent to the logic
analyzer's IP (Internet Protocol) address.
The control or data option specifies the type of access you want.
The directory name is the name of an empty directory in your computer's file
system to which the logic analyzer's file system will be mounted.
See the example on the next page.
Accessing the Logic Analyzer File System
To mount the file system via NFS
2-3