Agilent Technologies 1660C Series User Manual page 30

Using the X Window Interface
To start the interface
Example
Pseudo–telnet method using a UNIX computer
To enable windows to be initiated from the logic analyzer named lp1660C,
enter the following command on the computer running the X server :
xhost +lp1660C
To connect to the command parser socket of the logic analyzer named
lp1660C, enter:
telnet lp1660C 5025
Agilent Technologies logic analyzers are not telnet servers. The UNIX command
telnet is used to make a connection to the analyzer command parser, which
uses socket number 5025. A telnet server would normally not need to have the
socket specified.
To start the X Window interface on the computer whose IP address is
15.6.253.146 (and is running the X server) enter:
xwin on,"15.6.253.146:0.0"
If you are not planning on sending more commands to the logic analyzer,
close the telnet connection by typing the escape character, and then "quit"
when the telnet prompt appears. The escape character is often Control-];
your telnet program should tell you when it opens the connection.
3-6