Download Print this page

Wiring Diagrams - Assa Abloy Corbin Russwin SE LP10 9600 Series Installation Instructions Manual

Exit device with melr

Advertisement

Installation Instructions
SE LP10 9600 Series Exit Device
With MELR
Product
1-Black
SE LP10
12VDC
(Reader)
NEG
*Diagrams on following pages
Default Operation Mode:
Red LED 'ON' when powered.
Presenting a 13.56MHz or 125 kHz credential causes LED to briefly turn green and then return to
red state.
Presenting a FIPS 201 PIV credential causes LED to turn amber as credential is authenticated.
Reader emits a short beep when credential is successfully read. Reference Diagram #1.
Optional TAMPER Operation Mode:
Connect Yellow TAMPER wire from ElectroLynx cable to desired EAC panel control line.
Reference Diagram #1.
As appropriate, use the configuration card to activate desired mode on reader.
PIN 8 (Yellow – TAMPER)
PIN 6 (Blue – RX COM)
PIN 4 (Green – Data 0)
PIN 2 (Red – Reader POS)
PIN 1 (Black – Reader NEG)
PIN 3 (White – Data 1)
PIN 5 (Orange – RX NO)
PIN 7 (Brown - EGND)
Optional Alternate Indicator Mode:
Connect GREEN_LED input to switch controlled by panel. Shorting GREEN_LED to READER_NEG
(Black) with panel switch will override reader LED to keep it green.
PIN 8 (Yellow – Green LED)
PIN 6 (Blue – RX COM)
PIN 4 (Green – Data 0)
PIN 2 (Red – Reader POS)
PIN 1 (Black – Reader NEG)
PIN 3 (White – Data 1)
PIN 5 (Orange – RX NO)
PIN 7 (Brown - EGND)
Copyright © 2020, ASSA ABLOY Access and Egress Hardware Group, Inc. All
rights reserved. Reproduction in whole or in part without the express written
permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.

6) Wiring Diagrams

8 PIN CONNECTOR
2-Red
3-White
4-Green
ACCESS CONTROL DEVICES: SE LP10 Mortise, ElectroLynx wire Color / Function assignments
WIEGAND
WIEGAND
POS
DATA_1
DATA_0
5-Orange
6-Blue
7-Brown
RX
RX
EGND
GREEN_LED*
NO
COM
EGND
COLLECTOR
PIN 4 (Tan –DPS COM )
PIN 2 (Gray – Lock POS)
PIN 1 (Violet – Lock NEG)
PIN 3 (Pink – DPS NC)
PIN 4 (Tan –DPS COM )
PIN 2 (Gray – Lock POS)
PIN 1 (Violet – Lock NEG)
PIN 3 (Pink – DPS NC)
7
4 PIN CONNECTOR
8-Yellow
1-Violet
2-Gray
TAMPER
12/24 VDC
(LOCK RELAY)
OPEN
NEG
POS
INPUT
Note: NC= Normally Closed
NO= Normally Open
3-Pink
4-Tan
DPS
DPS
NC
COM

Advertisement

loading