Assa Abloy Corbin Russwin SE LP10 9600 Series Installation Instructions Manual page 16

6. Install Mortise and Outside Trim Assembly:
Install mortise lock following FM168 instructions, but do not install armored front at this time.
a. Feed lock wire through wire harness hole; seat lockbody firmly into mortised pocket (Fig. 6a).
b. Mount trim to door.
c. Fasten trim assembly to door using (2) 1/4-20 oval head screws and (2) finish washers (Fig. 6b).
Note: Finger tighten only.
7) Installation Instructions (Continued)
Fig. 6a
16
Installation Instructions
SE LP10 9600 Series Exit Device
Fig. 6b
Copyright © 2020, ASSA ABLOY Access and Egress Hardware Group, Inc. All
rights reserved. Reproduction in whole or in part without the express written
permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
With MELR