Advertisement
7. Install Outside Trim Assembly (Rim/CVR/SVR):
a. Make sure tailpiece is oriented vertically.
b. Feed trim wire harness through wire harness hole (Fig. 7).
c. Mount trim assembly to door pulling slack wire towards device side of door.
Note: Be careful not to pinch wire harness.
d. When mounting trim, lift tailpiece to pass through hole on device side (Fig. 7).
Note: Ensure tailpiece is still oriented vertically.
e. Fasten trim assembly to door using (2) 1/4-20 oval head screws and (2) finish washers (Fig. 7).
Note: Finger tighten only.
7) Installation Instructions (Continued)
18
Installation Instructions
SE LP10 9600 Series Exit Device
Reader
Harness
Harness
Trim
Wire
Harness
Fig. 7
Copyright © 2020, ASSA ABLOY Access and Egress Hardware Group, Inc. All
rights reserved. Reproduction in whole or in part without the express written
permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
With MELR
Wire
Hole
Advertisement
