Advertisement
Installation Instructions
SE LP10 9600 Series Exit Device
With MELR
8. Install Exit Device:
Follow instructions packed with device to secure device to door.
9. Install Head Cover:
a. Lay wire device harnesses across ¾" hole (Fig. 9a).
b. Tuck wires into hole when installing cover so that wires are not pinched between head cover
and door.
c. Attach head cover using (2) #8-32 flat head screws (Fig. 9b).
Fig. 9a
Copyright © 2020, ASSA ABLOY Access and Egress Hardware Group, Inc. All
rights reserved. Reproduction in whole or in part without the express written
permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
7) Installation Instructions (Continued)
Rim/SVR/CVR shown, assembly is same for mortise
¾
Use
tuck trim and
device wire
harness under
head cover
" hole to
Fig. 9b
19
Advertisement
