Advertisement
Installation Instructions
SE LP10 9600 Series Exit Device
With MELR
11. Connector Attachments:
a. Connect 6-pin connector from exit device to
6-pin connector on reader harness (Fig. 11a, b).
b. Connect 2-pin connector from exit device to
2-pin connector on reader harness (Fig. 11a, b).
For the following refer to page 17 for ElectroLynx door harness and lock interface:
c. Connect ElectroLynx
8-pin connectors of the reader harness (Fig. 11c).
Carefully tuck connected harnesses into one-inch hole in door.
NOTE: Neatly fold the wires into the remaining space to prevent pinching wires when
mounting inside escutcheon.
Do not offset connectors and be sure they are completely seated.
Reader
Harness
Copyright © 2020, ASSA ABLOY Access and Egress Hardware Group, Inc. All
rights reserved. Reproduction in whole or in part without the express written
permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
7) Installation Instructions (Continued)
4- and 8-pin connectors from the door harness to (black) 4- and
®
Fig. 11a
8-pin
ElectroLynx
Fig. 11c
4-pin
ElectroLynx
21
Fig. 11b
Advertisement
