Wiring Diagrams - Assa Abloy Harmony H1 Installation Instructions Manual

Wiring Diagrams

7
Product
1-Black
ACCESS CONTROL DEVICES: Harmony H1 Mortise, ElectroLynx wire Color / Function assignments
12VDC
Reader Power
SARGENT - NEG
HARMONY
SERIES,
H1 Mortise
PIN8 (Yellow – LED)
PIN 6 (Blue – RX)
PIN 4 (Green – Data 0)
PIN 2 (Red – Reader POS)
PIN 1 (Black – Reader NEG)
PIN 3 (White – Data 1)
PIN 5 (Orange – RX)
PIN 7 (Brown)
If your lock is configured with End of Line Resistors, reference instruction sheet A8191 for the wiring of
RX & DPS outputs.
Reader LED Configuration
The Harmony Series reader can be configured for (3) modes of LED operation:
Mode 1:
• Red LED 'ON' when powered.
• Presenting a 125kHz proximity card will cause LED to 'FLICKER' Green and return to Red state.
• Reference Diagram #1.
Note: LED wire is unconnected.
Mode 2:
• Green LED "ON" when powered.
• (No Flicker) after presenting valid 125kHz proximity card.
• Reference Diagram #2.
Note: LED wire must be connected to circuit GROUND of the system's power supply.
Mode 3:
• EAC Panel controls LED operation.
• Reference Diagram #3.
Note: Control of LED is a function of the EAC panel equipment (ie. Relay) to toggle between Green & Red.
Note: When LED wire is tied directly into EAC panel relay, no AC signals should be applied on wire or
door reader performance will be impacted (Ref. Diagram #3).
8 PIN CONNECTION
2-Red 3-White 4-Green 5-Orange
WIE- WIE- RX (NO/
GAND GAND NC)
POS DATA_1 DATA_0 REF.
STEP 2A
14
Harmony Series H1 Mortise Lock
6-Blue 7-Brown 8-Yellow 1-Violet
RX EGND LED 12 OR 24 VDC
(COM)
(LOCK RELAY
REF. REF. REF. NEG
STEP DIA- DIA-
2A GRAMS GRAMS
PIN 4 (Tan – DPS)
PIN 2 (Gray – Lock POS)
PIN 1 (Violet – Lock NEG)
PIN 3 (Pink – DPS)
A7877F • 800-810-WIRE (9473) • www.sargentlock.com
4 PIN CONNECTOR
2-Gray 3-Pink 4-Tan
DPS DPS
(NC) (COM)
POS DPS DPS