Advertisement
SN200/210 Bored Lock
Wiring Diagrams
5
Product
1-Black
12VDC
(Reader)
SN200 (UL294)
SN200
NEG
SN210
*Diagrams on following pages
If your lock is configured with End of Line Resistors, reference instruction sheet A8191 for the wiring of RX &
DPS outputs.
Wiegand Operation Mode:
•
Red LED 'ON' when powered.
•
Presenting a compatible credential causes LED to briefly turn green and then return to
red state.
UL294 / TAMPER Configuration:
•
Connect Yellow TAMPER wire from ElectroLynx cable to desired EAC panel control line.
Reference Diagram #1.
•
As appropriate, use the configuration card to activate desired mode on reader.
PIN 8 (Yellow – TAMPER)
PIN 6 (Blue – RX COM)
PIN 4 (Green – DATA_0)
PIN 2 (Red – Reader POS)
PIN 1 (Black – Reader NEG)
PIN 3 (White – DATA_1)
PIN 5 (Orange – RX NO)
PIN 7 (Brown - EGND)
Non-UL294 Configuration:
•
Connect GREEN_LED input to switch controlled by panel. Shorting GREEN_LED to READER_NEG (Black)
with panel switch will override reader LED to keep it green.
PIN 8 (Yellow – GREEN_LED)
PIN 6 (Blue – RX COM)
PIN 4 (Green – DATA_0)
PIN 2 (Red – Reader POS)
PIN 1 (Black – Reader NEG)
PIN 3 (White – DATA_1)
PIN 5 (Orange – RX NO)
PIN 7 (Brown - EGND)
A8282B • 800-810-WIRE (9473) • www.sargentlock.com
8 PIN CONNECTOR
2-Red
3-White
4-Green
ACCESS CONTROL DEVICES: SN200/210 Lockset, ElectroLynx wire Color / Function assignments
Communication
Type
WIEGAND
WIEGAND
DATA_1
DATA_0
POS
OSDP
OSDP
RS-485B
RS-485A
5-Orange
6-Blue
7-Brown
RX
RX
EGND
NO
COM
EGND
PIN 4 (Tan –DPS COM )
PIN 2 (Gray – Lock POS)
PIN 1 (Violet – Lock NEG)
PIN 3 (Pink – DPS NC)
PIN 4 (Tan –DPS COM )
PIN 2 (Gray – Lock POS)
PIN 1 (Violet – Lock NEG)
PIN 3 (Pink – DPS NC)
7
4 PIN CONNECTOR
8-Yellow
1-Violet
2-Gray
12/24 VDC
Function*
(LOCK RELAY)
TAMPER
GREEN LED
NEG
POS
n/a
Note: NC= Normally Closed
NO= Normally Open
3-Pink
4-Tan
DPS
DPS
NC
COM
Advertisement
