Advertisement
4. Install SE LP10 Reader and Trim Bezel (Continued):
1. Fit trim bezel around the reader. Ensure access hole in the bezel aligns with screw hole on reader.
The reader should be mounted so holes face bottom of door (Fig 4b).
2. Align top of reader with top of backplate. Pivot the reader down until seated. Guide wires as
needed to avoid pinching.
3. Secure the reader with (1) #6-32 x 3/8" Phillips or anti-tamper security torx screw to the mounting
plate (Fig 4b, c).
Outside of
Door
Trim Bezel
Reader
7) Installation Instructions (Continued)
Rim/SVR/CVR shown, assembly is same for mortise
Fig. 4b
Installation Instructions
SE LP10 9600 Series Exit Device
Fig. 4c
Copyright © 2020, ASSA ABLOY Access and Egress Hardware Group, Inc. All
rights reserved. Reproduction in whole or in part without the express written
14
permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
With MELR
Detail
Torx
security
screw
Advertisement
