Chapter 3
Control Program Integration
What You Need
• PanelView Component terminal.
• Ultra1500 drives.
• MicroLogix 1400 controller.
• Previously loaded software.
• Standalone Ethernet switch so that you can connect your personal computer to both the MicroLogix
1400 controller and PanelView terminal over an isolated Ethernet network.
Follow These Steps
Follow these steps to integrate your control program into the Simple Motion Control ladder logic.
36
Start
Review the Ladder Logic
Structure, page 37
Review the Modes of
Operation, page 38
Review the Program Mode
Commands, page 39
Customize the Axis User
Program Ladder Logic, page 41
Customize the Machine Control
Ladder Logic, page 42
Alter the Ultra1500 Drive
Follower Gear Ratio, page 44
Publication CC-QS008B-EN-P - December 2009