Before You Begin; Rockwell Automation Publication 2198-Um002E-En-P - February - Allen-Bradley Kinetix 5700 User Manual

Before You Begin

Remove and Replace Drive Modules
This chapter provides remove and replace procedures for Kinetix® 5700 drive
modules.
Topic
Before You Begin
Remove and Replace Kinetix 5700 Drive Modules
Start and Configure the Drive Module
ATTENTION: This drive contains electrostatic discharge (ESD) sensitive parts
and assemblies. You are required to follow static-control precautions when
you install, test, service, or repair this assembly. If you do not follow ESD
control procedures, components can be damaged. If you are not familiar
with static control procedures, refer to Guarding Against Electrostatic
Damage, publication 8000-4.5.2, or any other applicable ESD awareness
handbook.
When each drive module is installed, network settings are configured from the
setup screens. Before removing the module, revisit the Network menu and
make note of the static IP or DHCP settings. Refer to
page 146 to access those settings.
IMPORTANT If you intend to use the same Logix Designer application after replacing
your drive module, the new module must be the same catalog number as
the old module.
You also need these tools available before you begin removal and replacement
procedures:
• Screwdrivers (to loosen/remove screws)
• Voltmeter (to make sure that no voltage exists on drive connectors)

Rockwell Automation Publication 2198-UM002E-EN-P - February 2018

8
Chapter
Page
235
236
240
Configure the Drive on
235