Before You Begin - Allen-Bradley Kinetix 5500 User Manual

Before You Begin

Remove and Replace Servo Drives
This chapter provides remove and replace procedures for Kinetix® 5500 drives.
Topic
Before You Begin
Remove and Replace Kinetix 5500 Servo Drives
Start and Configure the Drive
ATTENTION: This drive contains electrostatic discharge (ESD) sensitive parts
and assemblies. You are required to follow static-control precautions when
you install, test, service, or repair this assembly. If you do not follow ESD
control procedures, components can be damaged. If you are not familiar with
static control procedures, refer to Guarding Against Electrostatic Damage,
publication 8000-4.5.2, or any other applicable ESD awareness handbook.
When each drive is installed, network settings are configured from the setup
screens. Before removing the drive, revisit the Network menu and make note of
the static IP or DHCP settings. Refer to
access those settings.
IMPORTANT If you intend to use the same Logix Designer application after replacing
your drive, the new drive must be the same catalog number as the old
drive.
You also need these tools available before you begin removal and replacement
procedures:
• Screwdrivers (to loosen/remove screws)
• Voltmeter (to make sure no voltage exists on drive connectors)
• Non-conductive probe for removing DC bus T-connectors
Rockwell Automation Publication 2198-UM001I-EN-P - May 2019
Chapter
Configure the Drive on page 113
8
Page
165
166
168
to
165