Table of Contents
Advertisement
Chapter 2
System Validation and Application Tips
Navigate the Operator Mode Screen
Follow this procedure to understand the Simple Motion Control Operator mode functionality.
1. To take control of the drive away from the MicroLogix 1400 controller, press Program to change the
Simple Motion Control screen to Operator mode.
Your screen will be similar to the one shown below.
2. Notice that the button in the lower right corner displays Operator. This indicates that the Simple
Motion Control CCBB is currently in Operator mode. Notice that the Enable, Disable, Forward,
Reverse, and Jog buttons have become visible. Also, the Program Speed numeric display has become an
Operator Speed numeric entry button. In addition, the button to go back to the Network Overview
screen (
) disappears, because the screen must be changed back to Program mode before leaving the
Simple Motion Control screen.
While the Simple Motion Control screen is in Operator mode, the commands sent to the Ultra1500 drive by
IMPORTANT
the PLC are done so through this screen. You can enable and disable the drive as well as execute a jog at a
custom speed and direction. While in Operator mode, the PLC Axis User Program and the corresponding
broadcast and program commands are not permitted to execute. The only actions that can be initiated are
through the Simple Motion Control Operator mode screen.
The indicators on the left side depict the same axis status data in Operator mode as they do in Program
mode. The numeric displays in the middle show the same Relative Position Feedback (Revs) and Relative
Speed Feedback (RPM) as Program mode does. However, Operator mode contains a numeric entry called
Operator Speed (RPM) instead of the Program Speed numeric display which is shown in Program mode.
Enable and Disable Buttons
28
Publication CC-QS008B-EN-P - December 2009
Advertisement
Table of Contents
