Table of Contents
Advertisement
System Validation and Application Tips
Introduction
In this chapter, you validate that communication is occurring as intended between the MicroLogix 1400
controller and the Ultra1500 drives, as well as between the MicroLogix 1400 controller and the PanelView
terminal.
The operation of the sample screens for Simple Motion Control Program mode and Operator mode is
described as well.
Before You Begin
• Verify that you have completed all of the steps in
• Verify that all the devices are connected per the Simple Motion Control CAD wiring diagram.
• Verify that the MicroLogix 1400 controller, Ultra1500 drive, and PanelView Component terminal
have power applied to them.
• Review the Connected Components Building Blocks Quick Start, publication CC-QS001, verifying
that you have completed all of the steps in Chapter 3 of that quick start.
What You Need
• Personal computer with Internet Explorer or Firefox web browser.
• PanelView Component terminal.
• Ultra1500 drives.
• MicroLogix 1400 controller.
• Previously loaded software.
• Standalone Ethernet switch so that you can connect your personal computer to both the MicroLogix
1400 controller and PanelView terminal over an isolated Ethernet network.
• Connected Component Building Blocks Overview CD, publication CC-QR001.
19Publication CC-QS008B-EN-P - December 2009
Chapter 1
of this document.
2
Chapter
19
Advertisement
Table of Contents
