Table of Contents
Advertisement
Chapter 1
Ultra1500 Drive Integration
Reset the Drive to Factory Settings
To be sure that the Ultra1500 drive is at a known starting point, you must reset the drive to its factory
settings.
To reset the Ultra1500 drive to factory settings, perform the following steps.
1. Right-click your Ultra1500 drive and
choose Commands>Reset To Factory
Settings.
2. At the confirmation dialog
box, click Yes.
3. Wait until the Ultraware application returns to the Workspace view and the Ultra1500 drive is ready.
If the Ultraware set-up wizard executes after going online with the drive, cancel it and return to the
Workspace view shown above. This will allow you to enter each required Ultra1500 drive parameter for
this building block application one by one as described in the sections below.
If you would like to use the setup wizard to configure most Ultra1500 drive parameters, feel free to do so,
but be sure to return to the Workspace view after you have completed the wizard so that you can
configure each required parameter for this building block application.
After the Ultra1500 drive is done resetting to its factory settings, continue to the next section.
14
Publication CC-QS008B-EN-P - December 2009
Advertisement
Table of Contents
