Follow These Steps; Multiple Drive Considerations; Configure Controller-To-Drive Communication - Allen-Bradley Ultra1500 Quick Start Manual

Simple motion control connected components building block, rockwell automation software

Hide thumbs Also See for Ultra1500:

Table of Contents

Chapter 2

System Validation and Application Tips

Follow These Steps

Follow these steps to verify that communication is occurring between your devices.

The Simple Motion Control Building Block supports 1-axis, 2-axis, and 3-axis configurations. When

completing Chapter 3 of the Connected Components Building Blocks Quick Start, publication CC-QS001,

be sure to use the correct RSLogix Control and PanelView Component HMI Programs for your particular

application. Additionally,

The RSLogix Control and PanelView Component HMI Programs must be the same version (1-axis, 2-axis, or

IMPORTANT

3-axis) for the Simple Motion Control Building Block to function correctly.

Once you have the correct RSLogix control program downloaded to the MicroLogix 1400 controller, you are

ready to validate the controller-to-drive communication. Perform the following steps to complete this

validation for each Ultra1500 drive.

Configure Controller-to-Drive

Communication, page 20

Configure PVc Terminal-to-

Controller Communication,

Test the Simple Motion Control

Functionality, page 26

Chapter 1

of this document should be completed for each of your Ultra1500 drives.

Start

page 23

Publication CC-QS008B-EN-P - December 2009

Table of Contents