Design Of Device - Inficon ELT3000 Translation Of The Original Operating Instructions

5 | Installation

5.3 Design of device

24 / 74
CAUTION
Danger due to dropping heavy loads
The battery leak detector is heavy and can injure persons and property through tipping
over or dropping.
► Only place the battery leak detector on a sufficiently stable and level surface.
NOTICE
Property damage due to vibration
Parts of the measurement technology rotate and must not be shaken. The parts
continue to rotate for several minutes after the Gas Detection Unit is shut down.
► Place the Gas Detection Unit, the Gas Control Unit and the optional vacuum
chamber only on a non-slip, stable, vibration and shock-free surface.
► Make sure that the gas detection unit is not exposed to shocks during operation for
at least five minutes after being switched off.
The battery leak detector consists of the following subcomponents: a Gas Detection
Unit, a Gas Control Unit and an optional vacuum chamber. The installation,
connection and startup of the battery leak detector must only be carried out by
INFICON employees.
• In order not to distort the measurement results, select a location where the room
temperature for the battery leak detector is as constant as possible.
• In order to avoid blocking the exhaust openings on the underside of the device,
place the feet of the unit on a firm, even surface.
• To easily reach the power switch on the back of the Gas Detection Unit, ensure
that there is sufficient free space behind the device.
• Make sure that the transport protection has been removed, see "Transport
protection [} 23]".
• Do not expose the device to direct sunlight.
DANGER
Health risk due to gases and vapors
Operation of the battery leak detector may produce hazardous vapors.
► Connect the Gas Detection Unit and the Gas Control Unit to an exhaust line.
► Do not inhale harmful gases or vapors.
► Ensure sufficient ventilation at the installation location.
ELT3000-Battery Leak-Detector-Operating-instructions-mina95en1-10-(2007)
INFICON