Special Settings (5-6); Square Mode Cutting (5-6-1); New Startup Sequence (5-6-2); Calibrate Tilt Sensor (5-6-3) - Husqvarna Automower Technical Manual

2.7.6 Special settings (5-6)

Square mode cutting (5-6-1)

The preset value for square mode cutting is 50%. The
value can be changed in exceptional cases, when an
Automower seems to use square mode cutting
frequently or infrequently. The higher the value, the
more infrequently Automower will carry out square
mode cutting and vice versa. See page 9 for more
information about square mode cutting.
To change the entry level: Select Square mode cutt.
and then place the cursor on Custom entry level and
press YES. State the required value and exit with
YES.
To revert to the original entry level: Select Square
mode cutt. and then place the cursor on Entry level
and press YES. Press YES when asked Reset?.
Reset square cutting is used to reset the time counter
for square mode cutting. An Automower must run
uninterrupted (mowing + charging) for about 13 – 14
hours before it can start square mode cutting. This
function is used, for example, if you wish to prevent
square mode cutting when the mower is moved from a
well-mown area to an unmown area. Select the
function and press YES when the cursor is on Yes to
reset.

New startup sequence (5-6-2)

This function can be used when a second-hand
Automower is sold. The new owner will then be asked
the start-up questions about language, date, and time
when the main switch is turned ON for the first time. In
addition, all settings on the Automower will be restored
to their original values, see Table 7: Factory settings
on page 40.
To select a new start-up sequence: Place the cursor
on New start-up sequence and press YES. Now press
YES when asked Select new startup?.

Calibrate tilt sensor (5-6-3)

To calibrate, i.e. reset the tilt sensor: Place the
Automower on a horizontal surface. Place the cursor
on Calibrate tilt sensor and press YES. Now press
YES when asked Calibrate tilt sensor?.
2. Special menu functions
Operating history
Test
Live data
Demo mode
Loop detection
Special settings
5-6
Automower from
Square mode cutt.
New start. sequence
Calibrate tilt sensor
STOP button
5-6-
override
39
™