Husqvarna Automower Technical Manual page 73

Manual test: Sensors
This function deals with the mower's collision sensors,
tilt sensor and lift sensor.
The topmost picture to the right of the screen shows
which collision sensor is active: None, Left, Right or
Both. The middle picture shows which angles are X
and Y as well as which direction refers to plus and
minus. The lower picture shows whether the lift sensor
is active.
The same values are presented as a horizontal bar to
the right of respective value boxes. A green bar colour
indicates an approved value. A red colour indicates the
value is too high or too low. A black colour indicates
that there is no limit value.
The collision sensors are the sensors that detect when
the mower has run into a fixed object. To test the two
collision sensors:
1. Hold the handle on the underside of the
Automower.
2. Press on different parts of the body.
In the Active collision sensors box you should now
see None, Left, Right or Both. This is also shown
in the picture to the right of the screen.
3. Continue to press on the body until you see that
both sensors work.
4. Autocheck, Service program
Automower from
3012-566
73
™