Husqvarna Automower Technical Manual page 87

Garden: Garden shape
Change Garden shape by clicking on the small arrow
next to the box and then highlight your selection.
Garden: Drive past loop
When the Automower mows it always passes the
boundary wire by a specific distance from the front
before the mower turns. The default distance is 27cm,
but this can be set as required.
The minimum value for Drive past loop is 15cm and
the maximum value is 50cm.
Garden: Follow loop
The Follow loop function has been in the mower
program since version 2.10. Autocheck detects
whether the connected mower has this function. The
Follow loop box is only shown if the function is
available.
The Follow loop box is divided into three tabs: General,
In and Out.
Garden: Corridor width
Under the General tab you set values for which
Corridor width the Automower should follow the
boundary wire and/or the guide wire. See page 14 for
more information.
The corridor width can be set according to a relative
scale from 0 to 20. The default value is 6. The
value 0 denotes no corridor and the value 20 denotes
the maximum corridor width.
Garden: Follow loop in
Under the In tab you set the delay in minutes from
when the Automower starts to search for the charging
station until it should follow the boundary wire and/or
the guide wire.
The default delay times are 11 minutes for boundary
wire and 7 minutes for guide wire. A delay of
99 minutes means that the function is deactivated.
4. Autocheck, Service program
Automower from
3012-580
3012-581
3012-582
87
™