Husqvarna Automower Technical Manual page 30

2. Special menu functions
• Efficiency (%) =
a measurement of how much of the total operating
time that the Automower has mown the lawn.
Efficiency is the mowing time divided by the
charging time+running time. Normally the
efficiency value should be around 50%.
• Time/charge (min) =
an average time for how long each charging
period has taken.
Mowing
• Prod. date =
the date when the mower was manufactured.
• Running (h) =
the accumulated time that the Automower has
been in operation. This time is the same as the
running time stated in the main menu on all user
info levels.
• Cutting (h) =
the accumulated time that the Automower has
mown the grass.
• Searching (h) =
the accumulated time that the Automower has
looked for the charging station.
• Fault, time (h) =
the accumulated time that the Automower has
been at a standstill and shown a fault message.
• Fault, no=
the accumulated number of fault events that have
occurred.
Charging
• Charge time (H) =
the accumulated time that the Automower has
charged the battery.
• Chargings OK =
the accumulated number of charges where the
battery has been fully charged.
Chargings OK is a measurement of the battery
age. A battery can normally take 1000 – 2000
charges.
NOTE! Chargings OK is reset both on the main
counter and in the trip counter when you reset
Trip Op. counters. If Trip Op. counters is reset
when replacing the battery, Chargings OK shows
the current age of the battery installed in the
mower.
NOTE! If the mower is run for long periods in
demo mode or if the Test OUT (3-2-5) function is
used frequently, Chargings OK can show a value
that is too high.
30 Automower from ™
Key data
Mowing
Charging
Search times
Key data
Mowing
Charging
Search times
Prod.date
Running
Cutting
Searching
Fault, time
Fault, no
Charge time
Chargings OK
Incompl. charg.
Docking attempts
Coll while docking
Timer mode