Replacing The Keypad; Replacing The Speaker - Husqvarna Automower Technical Manual

5. Repair instructions

5.10 Replacing the keypad

1. Dismantle the body.
2. Unscrew the four screws, torx 20, holding the
display cover.
3. Remove the cable to the keypad from the display
circuit card.
4. Unscrew the rubber cap on the main switch and
pass the main switch out through the hole.
5. Pull off the keypad and pass the cable out
through the hole.
6. Remove the protective film, press on a new
keypad and connect the cable to the
display-circuit card.
Make sure you press the keypad carefully and
firmly into position. There must be no loose
corners or air bubbles, as dirt and moisture can
enter under the keypad.
Ensure that the cable to the display circuit card is
connected the right way. If the cable is
connected incorrectly, the buttons will not
correspond with the menu functions.
7. Refit the main switch and screw on the rubber cap.
8. Check that the keypad works.
9. Assemble the body.

5.11 Replacing the speaker

1. Dismantle the body and chassis.
2. Press down the catch on the connector to the
speaker and remove the cable.
3. Unscrew the two screws, torx 20, holding the
speaker.
4. Lift out the old speaker and replace with a new
speaker.
5. Refit the screws and connect the cable.
6. Check that the speaker works.
7. Fit the chassis and body.
110 Automower from ™
3012-453
3012-446