To Start The Product For The First Time; Settings - Husqvarna AUTOMOWER 535 AWD Operator's Manual

B
A
Some of the functions with AIM are:
• It shows a map of the lawn in Automower
Connect app with charging station, boundary wire,
guide wire and islands.
• You can make work areas (A) and (B) in the
installation where you can set a schedule and
cutting height for each work area.
• You can make stay-out zones (C) in which the
product cannot enter and cut grass.
Note:
With the AIM function you can set work areas
and stay-out zones with a precision of approximately m /
ft.
The data collection for the AIM map starts automatically.
The product collects data while it operates and the map
is completed in 1-2 weeks. Remove temporary obstacles
on the lawn when the product operates and collects
data. If you change the installation of the wires or
charging station, you must do a new map. Read more
®
about AIM in the Automower
3.12 To start the product for the first
time
When the product is switched on for the first time, there
are some basic settings to do before the product can
start to operate.
1. Push the ON/OFF button for 3 seconds to switch
on the product.
Note:
®
The Bluetooth
minutes and the LED light is flashing blue. If the
product does not pair with Bluetooth
switch off the product. Wait until the LED status
indicator is not lit, and then switch on the product
again.
2. Enter the factory PIN code.
1427 - 006 - 25.11.2021
C
®
Connect app.
pairing mode is on for 3
®
in 3 minutes,
3. Log on to your Husqvarna account in the
Automower ® Connect app to pair your product with
®
Automower Connect.
Note:
It is recommended to pair your product
®
with Automower Connect to get access to all
functions in the product. If it is not necessary to
pair your product with Automower
the arrow symbol to continue to the menu.
®
4. Start Bluetooth on your mobile device.
My mowers in the Automower
5. Select
app, and then select the plus sign (+).
6. Select model. The Automower
searches for available products within short-range
®
(Bluetooth ).
7. Select product.
8. Obey the instructions in the Automower
app.

3.13 Settings

The product has factory settings but the settings can be
adapted to each work area.
3.13.1 Schedule
Schedule you can change the schedule settings for
In
the product.
The schedule function controls which hours the product
should operate and not operate. When the product is not
operating it is parked in the charging station. The
operating hours and days can be seen in an overview in
the Automower ® Connect app.
The default schedule setting allows the product to
operate around the clock 7 days a week. This is
normally a suitable setting for a work area
corresponding to the maximum capacity. If the work
area is less than the maximum capacity the schedule
should be used to minimize wear on the grass and to the
product.
To calculate the schedule setting, refer to
the schedule setting on page 21 .
3.13.1.1 To calculate the schedule setting
1. Calculate the dimension of your lawn in m
2 2
2. Divide the m / yd of the lawn with the
approximate operation capacity. Refer to table
below.
3. The result is equal to the number of hours that the
product must operate each day.
®
Connect, push
®
Connect
®
Connect app
®
Connect
To calculate
2 2
/ yd .
Installation - 21