Husqvarna Automower Technical Manual page 24

2. Special menu functions
Press Arrow up to display further information in this
display mode. The Ar-signal is then shown instead,
i.e. the loop signal measured through the rear loop
sensor. The guideline values of approximately
70 – 320 also apply for Ar. Press Arrow up to exit
this display mode.
The sensors display mode presents:
• Collision:
To test the collision sensors: Hold the handle on
the underside of the Automower. Press on
different parts of the body. The display shows
None, Both, Left or Right. Continue to press on
the body until you see that both collision sensors
work.
• Lift:
To test the lift sensor, lift up the front part of the
body. When the body is lifted up, the lift sensor is
activated and YES is shown on the mower's
display. When the mower is in the lowered position
NO is shown.
• Tilt X and Tilt Y:
When Automower is horizontal the values should
be max ±3. Inclination up and to the left give a
negative values.
• Mower position:
States Mower normal pos. or: Mower reversed.
The battery display mode presents:
• Voltage:
A value of about 21 V signifies a fully charged
battery and about 18 V signifies a discharged
battery.
• Charging:
Shows how much of the charge remains in the
battery. When the battery is fully charged the
charge is about 2200 mAh. When the charge has
dropped to about 700 mAh, the mower returns to
the charging station. If the ambient temperature is
high, the available capacity in the battery drops.
The mower adapts itself to this and then returns to
the charging station earlier.
• Current:
Shows the nominal regulated charging current.
The normal value for the charging current is
1750 mA.
• Batt. Temp:
Shows the temperature of the battery.
24 Automower from ™
Quality:
Restarts:
Collision:
Lift:
TiltX: 0
Mower normal pos.
Voltage:
Charging:
Current:
Batt. Temp:
Ar: 250
100%
0
NONE
NO
TiltY: 0
19.7 V
2000 mAh
1750 mA
30ºC