Repair Instructions - Husqvarna Automower Technical Manual

5. Repair instructions

All repairs to the Automower from Husqvarna™ should
be made indoors on a clean work bench to protect
sensitive components from moisture and dirt.
IMPORTANT INFORMATION
Oil, grease and dirt on electrical contactors
can cause intermittent faults on the
Automower. These faults only occur at times,
which makes them difficult to find. Never
touch sensitive electronic components with
your fingers, for example, connector pins or
components on a circuit card.
Ground yourself, for example against a
radiator or on the mower's chassis, before
you start to work on electrical components.
When you disconnect a cable from a
component: Always pull the connector and
NOT the cable.
Never use any form of silicone or the like
when repairing an Automower.
If possible check that replaced components
work before completing the assembly of
Automower.
All components on the Automower must be fitted
according to the values in Table 10: Tightening
Torques on page 116.
5. Repair instructions
Automower from 101
™