User Interface (5-3-2); Charging Station (5-3-3); 2�7�4 Special Settings (5-4); Loop Signal (5-4-1) - Husqvarna Automower 305 Technical Manual

User interface (5-3-2)

Keypad (5-3-2-1)
The display indicates which button is pressed down.
Press Arrow back to exit the test.
Display (5-3-2-2)
The display repeatedly lights and dims all pixels.
Press any key to exit the test.
Sound (5-3-2-3)
Move the cursor to Soundand press OK. The buzzer
then emits a short sound signal at the same time as a
note is shown in the display.
Press Arrow back to exit the test.

Charging station (5-3-3)

This function is used to quickly check that there
is a signal at A, F and Guide. The test also shows
whether the mower is receiving charge from the
charging station.
Place the mower in the charging station and start the
test by pressing OK.
The result of the test is OK if the conditions in the
table below are fulfilled.
Table 17: Test conditions charging station
Test Value OK
A-loop > 50
Guide wire > 50
F-loop -100 to -300
Charging voltage > 15 V
To carry out a thorough inspection of the signal
strength and the charge current, it is recommended
to use Battery (5-1-2) and Loop (5-1-3).
2� SPECIAL MENU FUNCTIONS
2.7.4 Special settings (5-4)
The sub-menu consists of two part menus which
giver access to specialised settings.
Info
History
Test
Special settings

Loop signal (5-4-1)

This function makes it possible to temporarily switch
off a mower's loop detection, i.e. the mower can be
run without the installed the charging station and
boundary wire. Demonstrating an Automower® at the
home of a customer is such an occasion.
This sub-menu offers two options, where Normal is
the normal operation mode.
•
Normal
• Override
The function is automatically set to Normal when the
mower is turned off and on using the main switch.

Calibrate tilt sensor (5-4-2)

To calibrate, i.e. reset the tilt sensor: Place the
Automower® 305 on a horizontal surface. Move the
cursor to Calibrate tilt sensor and press OK.
Demo mode (5-4-3)*
In demo mode the Automower® 305 works without
starting the blade disc. The mower runs for 4 minutes
followed by a short charge.
The Demo mode is ideal for use in installations such
as in shops or exhibitions.
* Available in a more recent version of the software
that was available at the time of printing this edition
of the Technical Manual.
Loop signal
Calibrate tilt sensor
Demo mode
English - 23