Husqvarna Automower Technical Manual page 68

4. Autocheck, Service program
You can cancel the test at any time by clicking on
Interrupt test.
When the test is completed and if a fault has been
found the following is asked: Test defect components
again? You can either choose to make the test again or
skip this.
After the test is completed, a summary of the faults
found is listed in the Test result box to the right of the
screen. Highlighting a defective component produces
an extract from the fault tracing guide, see page 118.
After Auto test is completed, the test is automatically
saved in the log file. The previous Auto test is
overwritten.
4.8.2 Manual test
Manual test allows you to test all components on an
Automower. The function consists of four parts:
Power/Motors, User interface, Sensors, and Loop.
When using Manual test, unlike Auto test, you need to
start and stop the components you wish to test. When
you have started a test, for example, of the wheel
motors, these will run until you click on Stop. This
means you have greater control over the test, which
makes the function suitable to use when testing a
specific component and when you want it to run for a
long period. Values are shown on screen throughout
the entire test.
Power/Motors
The values for battery voltage, battery current and
battery temperature are always shown irrespective of
the component being tested.
The same values are presented as a horizontal bar to
the right of respective value boxes. A green bar colour
indicates an approved value. A red colour indicates the
value is too high or too low. A black colour indicates
that there is no limit value.
When a component is started, all buttons except Stop
are dimmed. Consequently, it is not possible to change
to another component for testing until the ongoing test
is complete.
Test the wheel motors and blade motor forwards and
backwards by clicking on the corresponding button with
an arrow to the left respective arrow to the right.
68 Automower from ™