Replacing The Display - Husqvarna Automower Technical Manual

5.9 Replacing the display

1. Dismantle the body.
2. Unscrew the four screws, torx 20, holding the
display cover.
3. Remove all cables connected to the display
circuit card: upper section cable harness, stop
button, main switch and keypad.
NOTE!
Remove the cables by pulling respective
connectors.
4. Loosen the screw retainer and remove the
display.
5. Replace with a new display and reconnect all the
cables again. Ensure that the cable to the display
circuit card is connected the right way and that
the rubber grommet on the cable to the stop
button is fitted correctly. If the cable is connected
incorrectly, the buttons will not correspond with
the menu functions.
6. Check that the display works.
7. Screw on the display cover.
8. Assemble the body.
5. Repair instructions
3012-445
3012-315
Automower from 109
™