Husqvarna Automower Technical Manual page 83

IMPORTANT INFORMATION
Always let Autocheck complete a started
programming process! An interrupted
programming process can block the mower's
control box
To program:
1. Click on the Start programming button.
Autocheck retrieves the main program and the
language file from the Program folder. These files
are shown in the box to the right of the window.
Autocheck automatically selects the latest
program versions installed on your computer.
2. Autocheck asks a few questions about the design
of the mower before downloading the mower
program.
State in the box Choose component version which
type of collision pillar that the connected mower is
equipped with. Autocheck detects the year model
of the mower and preselects the options
accordingly. You only need to make changes if
you replace the collision pillar.
Autocheck can also ask whether the mower is
equipped with a lift sensor or not.
3. Click OK.
The message Programming finished is shown
when the main program and language file have
been transmitted to the mower.
Solving problems when programming
If the message No contact is shown during
programming, Autocheck has lost contact with the
mower. Programming must then be repeated.
When you do not have contact with the mower, you
must use Manual programming:
1. Select the Manual programming checkbox.
2. Click on Download main program.
3. Select the program to be downloaded to the
mower, se Table 2: Version of the mower program
on page 8 and click Open.
4. State in the Choose component version box which
type of collision pillar that the connected mower is
equipped with.
If you still receive the message No contact: Perform
the following actions, one at a time. If you do not
receive any contact with the mower, continue with the
next action.
4. Autocheck, Service program
Automower from
3012-734
83
™