Remove the bottle from the valve.
●
Replace the howitzer with the device
●
›››
Fig. 29
on the tyre valve.
1
Inflating the tyre
Screw the tyre inflation tube of the com-
●
›››
pressor
Fig. 29
on the tyre valve.
8
Check that the air evacuation screw is
●
›››
Fig. 29
closed
.
6
Connect the vehicle's drive system.
●
›››
Attach the connector
●
vehicle's 12 volt power outlet
Connect the air compressor with ON/OFF
●
›››
switch
Fig. 29
.
5
Keep the air compressor running until it rea-
●
ches 2.0 to 2.5 bar (29-36 psi/200-250 kPa).
A maximum of 8 minutes.
Disconnect the air compressor.
●
If it does not reach the pressure indicated,
●
unscrew the tyre inflator tube from the valve.
Move the vehicle 10m so that the sealant is
●
distributed throughout the tyre.
Screw the compressor tyre inflator into the
●
valve.
Repeat the inflation process.
●
If the indicated pressure still cannot be
●
reached, the tyre is too badly damaged. Stop
and request assistance from an authorised
technician.
38
Disconnect the air compressor. Unscrew
●
the tyre inflator tube from the tyre valve.
When the tyre pressure is between 2.5 and
●
2.0 bars, continue driving without exceeding
80 km/h (50 mph).
Attach the sticker
●
strument panel display, within the driver's
field of vision.
Check the pressure again after 10 minutes
●
›››
page
Fig. 29
to the
9
WARNING
›››
page
102.
When inflating the wheel, the air compres-
sor and the inflator tube may become hot.
Protect hands and skin from hot parts.
●
Do not place the hot flexible inflator tube
●
or hot air compressor on flammable mate-
rial.
Allow them to cool before storing the de-
●
vice.
If it is not possible to inflate the tyre to at
●
least 2.0 bars (29 psi / 200 kPa), the tyre is
too badly damaged. The sealant is not in a
good condition to seal the tyre. Do not con-
tinue driving. Seek specialist assistance.
CAUTION
Switch off the air compressor after a maxi-
mum of 8 operational minutes to avoid
overheating! Before switching on the air
compressor again, let it cool for several mi-
nutes.
Emergencies
›››
Fig. 29
to the in-
2
38.
Check after 10 minutes of driving
›››
Screw the inflator tube
Fig. 29
and check the pressure on the gauge
1.3 bar (19 psi / 130 kPa) and lower:
Stop the vehicle! The tyre cannot be
●
sealed sufficiently with the tyre mobility set.
You should obtain professional assistance
●
›››
.
1.4 bar (20 psi / 140 kPa) and higher:
Set the tyre pressure to the correct value
●
again.
Carefully resume your journey until you
●
reach the nearest specialised workshop with-
out exceeding 80 km/h (50 mph).
Have the damaged tyre replaced.
●
WARNING
Driving with an unsealed tyre is dangerous
and can cause accidents and serious in-
jury.
Do not continue driving if the tyre pres-
●
sure is 1.3 bar (19 psi / 130 kPa) and lower.
Seek specialist assistance.
●
again
5
.
6