Table of Contents
Advertisement
successively for a few seconds and will
stay on until the fault is rectified.
Driving data indicator (multifunc-
tion display)
The display of the travel data (multifunction
display) shows different values about the
journey and the consumption.
Change from one display to another
›››
Press the rocker switch
●
the wiper lever.
Driving data memories
The multifunction display has two automatic
memories:
1
Partial memory: The memory collects
journey and consumption data from
when the ignition is turned on until when
it is turned off. The memory is automati-
cally deleted if the journey is interrupted
for more than 2 hours. If the journey is
continued in less than 2 hours after the
ignition is switched off, the new data is
added to the data already stored in the
memory.
2
Total memory: The memory records the
values for a specific number of partial
trips, up to a total of 19 hours and 59 mi-
Instruments and warning/control lamps
nutes, or 1,999.9 km (miles), depending
on the model of instrument panel. On
reaching either of these limits, the mem-
ory is automatically erased and starts to
count from 0 again.
The selected memory will be shown in the
upper right-hand corner of the display.
Changing memory
With the ignition switched on, and display-
●
ing memory 1 or 2, briefly press button
›››
Fig. 62
memory to another
Fig. 62
on
2
Manually erasing memory 1 or 2
Select the memory that you wish to erase.
●
Hold button
●
seconds.
Possible displays
Time: Current time in hours (h) and minutes
●
(min).
Travelling time: This indicates the hours (h)
●
and minutes (min) since the ignition was
switched on.
Consumption: The current energy con-
●
sumption is indicated. While driving, it is indi-
cated in kilowatt-hours per 100 kilometres
(kWh/100 km). When the vehicle is stopped
with the drive system connected, the current
power consumption is indicated in kilowatts.
to change from one
1
pressed for about 2
Average consumption: Indication of the
●
average power consumption in kilowatt-hour
per 100 kilometres (kWh/100 km). The indica-
tion appears after travelling approximately
100 meters. Until then, dashes appear. The
indicated value is updated every 5 seconds
approx.
Range: It indicates the approximate dis-
●
tance in km that can still be travelled with the
current capacity of the battery charge if the
same driving style and consumption are
maintained. The calculation is made based
on current energy consumption, among other
factors. Keep in mind that autonomy can vary
very considerably if, for example, the climate
control is switched on or off or if the driving
profile is changed. In the calculation of the
autonomy, the difference between the tem-
perature of the passenger compartment and
the outside temperature when the climate
control is connected also influences. The fol-
lowing applies to the forecast autonomy: The
more energy the convenience consumers
use, such as climate control and seat heating,
the less energy will be available for the rest of
the journey.
Power availability: While driving, the cur-
●
rent available power of the electric engine is
displayed on the instrument panel display
›››
page
61.
Distance: Distance in km travelled since
●
the ignition was switched on.
»
65
Hide quick links:
Advertisement
Table of Contents
