Table of Contents
Advertisement
display. Additionally, a warning acoustic sig-
nal may sound.
The purpose of the warning is to remember to
switch off the ignition before leaving the vehi-
cle.
WARNING
If the vehicle keys are used negligently or
without proper attention, accidents and se-
rious injuries can occur.
Never leave any key inside the vehicle
●
when exiting. The key can connect the drive
system and certain electrical equipment
can be operated, such as electric windows,
which can cause serious injuries.
When locking the vehicle, never leave
●
any child or anyone who may need help in-
side. They could be trapped in the car in an
emergency and will not be able to get
themselves to safety. Thus, for example,
depending on the season, a closed vehicle
can reach very high or very low tempera-
tures that can cause serious injuries and ill-
nesses or even death, especially in the
case of young children.
Never remove the key from the ignition
●
lock when the vehicle is moving. The steer-
ing column lock could suddenly become
locked and it would be impossible to steer
the vehicle.
The bit of the vehicle key must be com-
●
pletely unfolded and locked.
Drive system and driving
Do not fix objects that exceed 100 g in to-
●
tal to the vehicle key.
Note
If the vehicle key remains for a long time
●
in position
of the ignition lock with the
2
electric drive system disconnected, the 12-
volt battery will discharge.
The key can only be removed from the ig-
●
nition lock if the selector lever is in position
P. If necessary, press the lock key on the
selector lever and release it again.
The key can only be removed from the ig-
●
nition lock if the selector lever is in position
P. If necessary, press the lock key on the
selector lever and release it again.
Connecting the drive system
When the electric drive system is connected,
the electric engine is connected and the ve-
hicle is ready to move.
Requirements for connecting the drive
system
The drive system can be connected when the
following conditions are met:
The level of charge of the high-voltage bat-
●
tery is sufficient.
There is no charging cable plugged in.
●
The temperature of the high-voltage bat-
●
tery is within the operating range.
Connecting the drive system
›››
Connect the ignition
page
●
Press the brake pedal and keep it pressed.
●
If the brake pedal is not pressed, the control
lamp comes on
in green and the instru-
ment panel displays the message The brake
.
pedal is not pressed
Set the selector lever to the N position or
●
engage the parking lock.
Keep turning the key in the ignition lock
●
without stepping on the accelerator. Keep the
key in this position until the control lamp
comes on. When the control lamp
on in the instrument panel display, release
the key. The needle of the power indicator
goes from
to
.
If the control lamp
does not turn on,
●
interrupt the process and repeat it.
When you start to move, release the hand-
●
brake.
Noises before starting to move
When you connect the drive system you may
hear a "click". This is quite normal, and no
cause for concern.
140.
come
»
141
Hide quick links:
Advertisement
Table of Contents
