Charging Cable For Charging Stations (Ac) - Seat Mii Electric Owner's Manual

How to maintain the protection device and
the charging connectors in good condition:
After using the charging cable, replace the
●
protective caps.
Protect them from intense solar radiation
●
(the outside temperature should not exceed
50°C (122°F)).
Do not drop them.
●
Do not insert them in liquid.
●
In the event of operating faults, SEAT recom-
mends the charging cables are checked by
one of its dealers.
If there is a fault in the power socket or in the
electrical installation, seek assistance from a
technician specialised in electrical installa-
tions.
WARNING
Never use damaged charging connectors
or cables. Before using the charging con-
nectors or cables, always check they are
not damaged.
WARNING
Always plug the charging cable for power
sockets directly into a power socket. Never
use the charging cable in combination with
an extension cable, a cable reel, a power
strip or an adapter, such as a travel adapt-
er or a timer. Otherwise this could lead to
injuries caused by fire or the charging ca-
High-voltage battery
ble or the electrical installation of the
property could be damaged.
WARNING
Never charge the battery using unknown
power sockets or electrical installations, or
those which have not been checked by du-
ly qualified technicians. Even very low
charging currents can cause important
damages, especially fires, when using
power sockets or electrical installations
that are in poor condition. In this case, seek
assistance from a technician specialised in
electrical installations.
WARNING
Loose or unsecured objects can cause seri-
ous injury in case of sudden manoeuvring
or braking or in case of an accident.
Always store the charging cable safely.
●
CAUTION
A specialist in electrical installations
should check the charging cable on a regu-
lar basis. A tester adapter will be needed to
check the charging cables.
Note
Take into consideration the maximum ca-
pacity of the electrical circuit used. If the
charging cable is plugged in along with
other electrical consumers into a power
socket on the same electrical circuit, this
could cause the fuse to trip. In this case, the
high-voltage battery will not charge. Dis-
connect all other electrical consumers
from the electrical circuit or use another
circuit. In this case, seek assistance from a
technician specialised in electrical instal-
lations.
Charging cable for charging sta-
tions (AC)
In the luggage compartment: charg-
Fig. 157
ing cable for charging stations (depending on
the equipment).
Depending on the equipment, the vehicle will
come with a charging cable for charging sta-
›››
tions (alternating voltage) Fig.
Bear in mind the procedure to be followed for
charging with alternating voltage
›››
page 169.
157.
»
175