External Audio Source Connected To The Aux-In Multimedia Socket; Controlling Playback; Adjust The Playback Volume; Connecting An External Audio Source To The Aux-In Multimedia Socket - Seat Mii Electric Owner's Manual

You may still need to manually start playback
on the Bluetooth source. When playback on
®
the Bluetooth ® audio source is stopped, the
Infotainment system remains in Bluetooth
Audio mode.

Controlling playback

The extent to which the Bluetooth
source can be controlled via the Infotainment
system depends on the connected Blue-
tooth audio source.
®
With media players that support the AVRCP
Bluetooth profile, playback on the Blue-
®
tooth audio source can be automatically
®
started or stopped when the unit is switched
to Bluetooth Audio mode or to a different au-
®
dio source. In addition, it is possible to view or
change the track via the Infotainment system.
WARNING
Do not perform the pairing and connection
process while driving. This may cause an
accident!
Note
Due to the large number of possible Blue-
●
tooth ® audio sources, it is not possible to
guarantee fault-free operation of all de-
scribed functions for all these sources.
To operate the media and phone with the
●
Bluetooth device connected, please read
®
Operating modes
the electronic Instructions Manual of the
manufacturer.
Only use compatible Bluetooth
●
®
You can request information about compat-
ible Bluetooth
ised Service or online.
audio
®
External audio source connected to
the AUX-IN multimedia socket
Depending on the version of the vehicle, there
is an AUX-IN connection on the front of the ra-
›››
page 114, in the glove compartment on
dio
the passenger side, on the centre console or
on the armrest between the front seats.
The AUX-IN multimedia connection can only
be used with a 3.5 mm jack.
A connected external audio source is played
over the vehicle speakers and cannot be
controlled via the radio system controls.
The AUX-IN multimedia connection must be
activated in the system settings so it can be
displayed on the Media selection menu
›››
page 126.
Connecting an external audio source to
the AUX-IN multimedia socket
Lower the base volume on radio.
●
Connect the external audio source to the
●
AUX-IN multimedia socket.
® devices.
products at a SEAT Author-
®
Start playback on the external audio
●
source.
In the Media mode, press the
●
ment button to display the Media source se-
›››
lection menu again page 126.
Press the function button.
●

The output volume of a connected external
audio source should be adjusted to the vol-
ume of the other audio sources.

Adjust the playback volume

If you need to increase the playback volume
for the external audio source, first lower the
base volume on the radio system.
If the sound from the external audio source is
too low, increase the output volume on the
external audio source, if possible. If this is not
enough, adjust the input volume in the sys-
tem settings to Level 2 or Level 3 .
If the sound from the connected external au-
dio source is too loud or distorted, lower the
output volume on the external audio source,
if possible. If this is not enough, change the
input volume to Level 2 or Level 1 .
Note
When the playback from the external au-
●
dio source ends or the connection to the
AUX-IN socket is interrupted, the radio goes
back to the AUX menu.
equip-

»
129