Limiting The Charging Current; Failure Indications - Seat Mii Electric Owner's Manual

If it is still possible to charge, in addition to the
operating display flashing, the red warning
›››
lamp Fig. 158 will also appear. The charg-
ing current is automatically reduced. The
charging current will increase again when the
charging cable has cooled down sufficiently.
In the event of the charging process having
paused due to the protection device, the op-
erating display will turn off and a green warn-
ing lamp will flash. The red warning lamp will
flash. Unplug the charging cable and let it
cool down. If the fault occurs again, consult a
specialised workshop.

Limiting the charging current

The charging cable limits the charging cur-
rent based in the existing power supply. De-
pending on the power socket of the country
in question, the maximum charging current
may be 6, 8 or 10 A.
The management of the battery charge ena-
bles to select a lower or maximum charging
current.

Failure indications

If the warning lamp flashes or is red with-
4
out the operating display ,
1 2
maining on, this indicates there is a failure.
The charging process will pause or cancel.
Check the failure display and consult a spe-
cialised workshop if necessary.
High-voltage battery
Display
›››
Fig. 158
1 flashes, 4 on or
flashing
2 flashes, 4 on or
flashing
3 4
flashes, on or
flashing
CAUTION
Seek information regarding the appropri-
ate charging cable and the maximum per-
mitted charging current before travelling
abroad. If possible, use the charging cable
supplied in the country in question.
Note
The charging cables supplied in countries
other than Norway are often not appropri-
ate for charging from power sockets. Nor-
wegian charging cables are not fitted with
control lamp
ent electrical network.
Note
or re-
3
If there is another consumer connected si-
multaneously to the electrical network dur-
ing the charging process or if the vehicle is
in the vicinity of high-voltage cables, it is
possible that the charge cannot be per-
Meaning
Failure in the power supply.
Failure in the protection de-
vice.
Failure in the vehicle.
because they use a differ-
1
formed from a power socket. Simultaneous
connections to the electrical network:
Connection of a charger for the 12-volt
●
starter battery.
Contact with a working equipment con-
●
nected to the electrical network, i.e. an ele-
vating platform.
177