connected to it can be used when the igni-
tion is switched on.
Should a connected electrical device
●
overheat, switch it off and unplug it imme-
diately.
CAUTION
Take into account the operating instruc-
●
tions of the devices to be connected!
Never exceed the maximum power rating
●
as this could damage the vehicle's general
electrical system.
To avoid damaging the vehicle's electri-
●
cal system, never connect accessories
supplying power such as solar panels or
battery chargers for charging the 12-volt
battery to the 12-volt power socket.
Only use accessories with approved
●
electromagnetic compatibility according
to current regulations.
To avoid damage due to voltage fluctua-
●
tions, switch off all devices connected to
the 12 V power sockets before switching the
ignition on or off and before starting the
drive system.
Never connect an appliance to the 12 volt
●
power socket that consumes more than the
power indicated in watts. Exceeding the
maximum power absorption could damage
the vehicle's electrical system.
Transport and practical equipment
Note
Unshielded equipment can cause inter-
●
ference on the radio equipment and the ve-
hicle's electrical system.
Interference can occur on the radio's AM
●
waveband if electrical appliances are used
near the aerial.
Smartphone support
Portable smartphone support
Assembling the universal support and
Fig. 107
the holding arm.
On the centre console: close the
Fig. 108
compartment where the infotainment system is
housed.
Removing the smartphone
Grip the smartphone firmly with one hand.
●
›››
Press the unlock button
Fig. 108
●
the upper arm of the universal support is re-
leased.
Remove the smart phone and, as the case
●
may be, unplug any cables.
Inserting a smart phone
If necessary, install the smartphone hous-
●
›››
ing
.
Connect the smartphone.
●
Place the smartphone on the bottom
●
mountings. To adjust the lower fittings, press
›››
the button
Fig. 108
4
until
5
»
103