Appendix 8.1 Copyright; Terminology/Glossary; Change Information Manual - Optimum OPTimill MH 35G Operating Manual

8 Appendix
8.1 Copyright
This document is protected by copyright. All derived rights are reserved, especially those of
translation, re-printing, use of figures, broadcast, reproduction by photo-mechanical or similar
means and recording in data processing systems, either partial or total.
Subject to technical changes without notice.
8.2

Terminology/Glossary

Term
Milling table
Taper mandrel
Workpiece
Drawbar
Tool - quick clamping system
Drill chuck
Collet
Drill-mill head
Quill
Milling spindle
Drilling table
Taper mandrel
Quill lever
Quick action - drill chuck
Workpiece
Tool
Emergency stop
Emergency switch-off
8.3

Change information manual

Chapter
2 ; 4.3
parts
1.1 ; CE
3 ; 4.7.1
EN
MH35G│MH35V
78
Explanation
Supporting surface, clamping surface for the workpiece with traverse in
X and Y directions
Tool housing taper, drill taper, drill chuck taper.
piece to be milled, drilled or machined.
Threaded rod to fix the taper mandrel in the quill.
System with collet instead of a drawbar.
Drill bit adapter
Holder for end mill
Upper part of the milling machine
Hollow shaft in which the milling spindle turns.
Shaft activated by the motor
Supporting surface, clamping surface
Cone of the drill or of the drill chuck
Manual operation for the drill feed
Drill bit adapter can be fixed by hand.
Part to be drilled, part to be machined.
Milling cutter, drill bit, etc.
Stops the operation of a machine.
Interrupts the power supply to the machine.
Short summary
Speed range MH35V; Switching the machine on
Spare part drawings
Update of rating plate MH35V ; Update CE declaration
Interdepartmental transport+ speed tables + Circuit dia-
gram integrated tool control MH35G_MH50G
Translation of original instruction
new version number
1.0.1
1.0.2
1.0.3
1.1.0
Version 1.1.0 - 2020-08-07