Table of Contents
Advertisement
8
Appendix
8.1
Copyright
This document is protected by copyright. All derived rights are reserved, especially those of
translation, re-printing, use of figures, broadcast, reproduction by photo-mechanical or similar
means and recording in data processing systems, either partial or total.
Subject to technical changes without notice.
8.2
Terminology/Glossary
Term
Milling table
Taper mandrel
Workpiece
Tie rod
Tool - quick clamping system
Drill chuck
Collet
Drill-mill head
Quill
Milling spindle
Drilling table
Taper mandrel
Quill lever
Quick action - drill chuck
Workpiece
Tool
Emergency stop
Emergency switch-off
8.3
Change information operating manual
Chapter
2 , 4 , 6
1, 2 , DRO5 , parts
4.10.1
0, 1 , 4 , 7 , parts
3 ; 3.11
Version 2.5.1 - 2020-07-28
Explanation
Supporting surface, clamping surface for the workpiece with traverse in
X and Y directions
Tool housing taper, drill taper, drill chuck taper.
piece to be milled, drilled or machined.
Threaded rod to fix the taper mandrel in the quill.
System with collet instead of a drawbar.
Drill bit adapter
Holder for end mill
Upper part of the milling machine
Hollow shaft in which the milling spindle turns.
Shaft activated by the motor
Supporting surface, clamping surface
Cone of the drill or of the drill chuck
Manual operation for the drill feed
Drill bit adapter can be fixed by hand.
Part to be drilled, part to be machined.
Milling cutter, drill bit, etc.
Stops the operation of a machine.
Interrupts the power supply to the machine.
Short summary
Quick tool system BT20 replaced with drawbar
Enhanced by MH20VL and MH20VLD (DRO5)
Updating of the illustrations
Milling head with fine feed for spindle sleeve + new item
no. on frontpage
Interdepartmental transport ; Holes for DRO on Panel
Translation of original instructions
new version number
1.0.1
2.0
2.0.1
2.5.0
2.5.1
MH20V | MH20VL | MH20VLD
GB
65
Advertisement
Table of Contents
