Optimum OPTimill MH 35G Operating Manual page 25

The installation site must be free from vibrations also at a distance of presses, planing

machines, etc.
Provide sufficient space for the personnel preparing and operating the machine and trans-

porting the material.
Also make sure the machine is accessible for setting and maintenance works.


Check that the milling machine foundation is horizontal with a spirit level.

Check that the foundation has sufficient load-bearing capacity and rigidity.
ATTENTION!
Inadequate rigidity of the foundation will cause interaction of vibrations between the
milling machine and the foundation (resonant frequency of the components). If the
rigidity of the overall system is insufficient, critical speeds with annoying vibrations will
be reached very quickly and lead to bad milling results.

Place the milling machine on the provided foundation.

Fix the machine base to the substructure through the holes pre-drilled for this purpose.
WARNING!
The nature of the foundation and type of fixings used to secure the machine base to the
foundation must be capable of absorbing the loads caused by the milling machine. The
foundation must be level. Check that the milling machine foundation is horizontal by
using a spirit level.
Fix the milling machine to its foundation at the recesses provided on the machine base for this
purpose.
Version 1.1.0 - 2020-08-07 Translation of original instruction
MH35G│MH35V EN
25