Table of Contents
Advertisement
8
Appendix
8.1
Copyright
This document is protected by copyright. All derived rights are reserved, especially those of
translation, re-printing, use of figures, broadcast, reproduction by photo-mechanical or similar
means and recording in data processing systems, either partial or total.
Subject to technical changes without notice.
8.2
Terminology/Glossary
Term
Cross table
Taper mandrel
Workpiece
Drawbar
Drill chuck
Collet
Drill-mill head
Quill
Milling spindle
Drilling table
Taper mandrel
Quill lever
Quick action - drill chuck
Workpiece
Tool
Emergency stop
Emergency switching off
8.3
Change information operating manual
Chapter
2 , 4 , 6
5 , 7
3
parts
Version 1.0.4 - 2020-12-15
Explanation
Bearing surface, clamping surface for the workpiece with X-axis and Y-
axis travel
Cone of the tool holder, cone of the drill or of the drill chuck
piece to be milled, drilled or machined.
Threaded rod to fix the taper mandrel in the quill.
Drill bit adapter
Holder for end mill
Upper part of the milling machine
Hollow shaft in which the milling spindle turns.
Shaft activated by the motor
Supporting surface, clamping surface
Cone of the drill or of the drill chuck
Manual operation for the drill feed
Drill chuck can be fixed by hand.
Piece to be drilled or machined.
Milling cutter, drill bit, etc.
Stops the operation of a machine.
Interrupts the power supply of the machine.
Short summary
Drawbar replaced with quick tool system BT30
Cleaning contactless position switches.
Interdepartmental transport
Wiring diagram, merged boards
Translation of original operating manual
new version number
1.0.1
1.0.2
1.0.3
1.0.4
MH25SV
EN
65
Advertisement
Table of Contents
