Decommissioning; Dismantling; Disassembly; Packing And Loading - Optimum OPTimill MH 35G Operating Manual

8.7.1

Decommissioning

CAUTION!
Disused equipment must be decommissioned in a professional manner in order to avoid
later misuse and danger the environment or persons.
Disassemble the machine if required into easy-to-handle and reusable assemblies

and component parts.
Dispose of machine components and operating fluids using the intended disposal

methods.
8.7.2

Dismantling


Pull the power cord or unplug the connection cable and disconnect the connection cable.
8.7.3

Disassembly


Remove the drive motor.

Drain the oil from the gear box.
8.7.4

Packing and loading


Place the machine on a pallet for removal.

Lifting the machine on page 24
8.8

Disposal of new device packaging

All used packaging materials and packaging aids from the machine are recyclable and gener-
ally need to be supplied to the material reuse.
The packaging wood can be supplied to the disposal or the reuse.
Any packaging components made of cardboard box can be chopped up and supplied to the
waste paper collection.
The films are made of polyethylene (PE) and the cushion parts are made of polystyrene (PS).
These materials can be reused after reconditioning if they are passed to a collection station or
to the appropriate waste management enterprise.
Only forward the packaging materials correctly sorted to allow direct reuse.
8.9

Disposal of lubricants and cooling lubricants

ATTENTION!
Please imperatively make sure to dispose of the used coolant and lubricants in an
environmentally compatible manner. Observe the disposal instructions of your municipal
waste management companies.
INFORMATION
Used coolant emulsions and oils should not be mixed since it is only possible to reuse oils with-
out pre-treatment when they have not been mixed.
The disposal instructions for used lubricants are made available by the manufacturer of the
lubricants. If necessary, request the product-specific data sheets.
Version 1.1.0 - 2020-08-07 Translation of original instruction
MH35G│MH35V EN
81