Table of Contents
Advertisement
Interval
Where?
When necessary
Version 1.1.0 - 2020-08-07
What?
How?
For oil change use an appropriate collecting tray of suffi-
cient capacity.
Remove the filler hole plug.
Remove the oil drain plug.
If necessary use sealing tape for drain plug.
Fill in the open lubricating system of the geared drill about
1 liters of oil.
Check if the oil level is correct via the sight glass. The sight
glass (oil level dropped) must be half covered.
Gearbox
ventilation,
Fill cap
Sight glass
Oil outlet
An larger amount of backlash in the milling head spindle can
be reduced by adjusting the spindle nut. The two-piece spin-
dle nut is adjusted by the lower spindle nut half so that the
thread flanks is reduced by rotating. After the reset, it is neces-
sary to check if there is still smooth movement over the entire
path, otherwise wear is considerably increased due to friction
between the spindle nut and the spindle.
Readjusting
Z axis
Img.5-2:
Milling head
Translation of original instruction
Img.5-1: Gear oil level
Clamping bolts
lower spindle nut
MH35G│MH35V
EN
43
- Quick Links:
- Rating Plates
Hide quick links:
Advertisement
Table of Contents
