Table of Contents
Advertisement
3.2
Unpacking
Install the machine close to its final position before unpacking. If the packaging shows signs of
having possibly been damaged during transport, take the appropriate precautions to prevent
the machine being damaged when unpacking. If damage is discovered, the carrier and/or ship-
per must be notified immediately so the necessary steps can be taken to register a complaint.
Examine the complete machine carefully and check whether all materials, such as shipping
documents, instructions and accessories have been delivered with the machine.
3.3
Installation and assembly
3.3.1
Installation site requirements
The power plug of the milling machine must be readily accessible.
The illumination of the workplace must be designed in such a manner that an illumination of
500 Lux is attained at the tool tip.
If this is not guaranteed with the normal installation site lighting, workplace lights (available as
an option) must be used.
In order to achieve sufficient safety against falls by slipping, the accessible area in the mechani-
cal machining zone of the machine must be equipped with a slip resistance. The slip resistant
mat and/or the slip resistant floor must be at least R11 according to BGR 181.
The used shoes must be suitable for being used in those machining areas. The accessible
areas must be cleaned.
Organize the working area around the milling machine according to the local safety regulations.
The work area for operation, maintenance and repair must not be restricted.
3.4
Lifting the machine
WARNING!
Danger of crushing and overturning. Proceed carefully when
lifting, installing and assembling the machine.
Fix the load lifting gear around the drilling-milling head. Use a
lifting sling for this purpose.
Lock all clamping levers on the drilling-milling machine before
you lift it.
Make sure that no add-on pieces or varnished parts are dam-
aged due to the load suspension.
Take care with the centre of gravity of the machine.
Dimensions, balance point on page 26
3.4.1
Assembly
Organise the working area around the machine according to the local safety regulations. The
work area for operation, maintenance and repair must not be restrictive.
Follow the prescribed safety areas and escape routes according to VDE 0100 part 729 as
well as the environmental conditions for the operation of the CNC machine.
The main switch of the machine must be freely accessible.
The machine must only be installed and operated in a dry and well-ventilated place.
Avoid places near machines generating chips or dust.
EN
MH35G│MH35V
24
Translation of original instruction
Version 1.1.0 - 2020-08-07
- Quick Links:
- Rating Plates
Hide quick links:
Advertisement
Table of Contents
