Table of Contents
Advertisement
OPERATION
3.5
Working With
Sources and
Channels
3-14
DLV 1280
User's Manual
NOTES: 1) Numbers are at either end of the alphabet. If desired, scroll with
or
. Or enter numbers using the number keys on the keypad.
When a number is required, such as when you are specifying a projector number,
a special highlighted numeric field appears on screen. Press a numbered key on
the keypad to begin entering the desired number. Note that once you enter the
first digit, it replaces all of the old.
•
To delete the last digit entered press
•
To cancel (revert back to the old number), press
•
To accept the new number, press
Whenever the projector is not at presentation level, such as when there is a
slidebar, menu, message or test pattern present, you have limited time in which
to make a keypad entry before the projector returns to presentation level. These
time-outs vary depending on the specific function at hand, as shown in the
following chart:
All menus and options
Slidebar (direct access)
Source entry
Direct control entry
Other
NOTE: See Section 2, Installation and Setup, for a complete explanation of how
to connect the various types of sources to the projector.
Once you connect a source to the projector, such as a VCR or computer, you can
display the image from it by pressing the appropriate "direct" key:
or
at any time.
Or, perhaps if your system includes many sources, press
method of selection. Depending on how you have defined it from within the
Preferences menu, the
•
to select the desired channel. Or press
the present channel. Note too that you can cycle up or down through this
list of channels simply by pressing
NOTE: Only those sources marked as "In Menu" (default) in the Channel
Edit menu appear. See Editing Channels, below.
•
retained in projector memory.
•
of the switcher used, then enter the number of the slot for the source.
15 minutes
5 seconds
5 seconds
5 seconds
15 minutes
key will trigger one of the following:
of channels retained in projector. Highlight and press
of channel numbers representing source setups
of a source location (default). First enter the number
at any time
to use another
to cancel and return to
or
from presentation level.
,
,
Advertisement
Table of Contents
