Christie HAL Series User Manual page 17

INSTALLATION & SETUP
2-14
DLV 1280
User's Manual

If you have an S-Video (SVHS) source, connect it to the projector's rear input
panel at Depending on the source, use either the two BNC connectors
labeled " and
connector labeled "
See Figure 2-17.
Figure 2-17. Connecting an S-Video Source
To control audio levels in an audio/visual system, connect pre-
amplified (line level) audio inputs to the left and right audio inputs labeled

If you want to connect an extra S-Video source, connect to
and blue BNC connectors (labeled " " and " ") and use
sure to connect the "Y" signal (luminance) to red, the "C" signal (chrominance)
to blue. See Figure 2-18.
Figure 2-18. Connecting an Extra S-Video Source
" (luminance and chrominance) or use the 4-pin mini DIN
"— do not use both types of connectors simultaneously.
.
using the red
. Make