Connecting To Power - Christie HAL Series User Manual

2.5 Connecting to
Power

Connect YCrCb video (component video) sources as shown in Figure 2-19. Note
that if you use the video inputs you will connect to both
simultaneously for the single source. The projector detects such a connection as
a source, and
NOTES:1) If you connect YCrCb video using Vid 1 and Vid2, you cannot also
connect an S-video source using the 4-pin DIN. 2)DLV 1280 does not
automatically distinguish between a YCrCb signal and other RGB sources. When
using YCrCb video, turn the YCrCb option on in the Image Settings menu. See
3.6, Adjusting the Image.
Connect pre-amplified (line level) audio inputs to the left and
right audio inputs labeled
connected (see Figure 2-19).
Plug the AC power cord
into the input socket
located at the left rear of
the projector (Figure 2-
20). Plug the three-
prong end of the power
cord in a grounded AC
outlet. Input voltage to
the projector must be
between 90 and 264
VAC, 50 or 60 Hz. The
power source must be
capable of supplying
900 watts of power to
the projector.
NOTE: Once the projector is turned off, the lamp cooling fans will continue to
run for approximately five minutes to cool the lamp. The fans will then
automatically shut off. Do not unplug the power cord before the fans stop.
cannot be used.
Figure 2-19. Connecting “YCrCb” Video
or depending on where your video input is
Figure 2-20. Connecting Power
INSTALLATION & SETUP
and
DLV 1280
User's Manual
2-15